
Instructions for Changing Color in Front Panel Pack
(For
Modek so Equipped)
WARNING: As with any cut metal edge, use care in
changing panels to avoid personal injury or damage
to colored panels.
Remove one side trim
NOTE: Either side trim may be removed to change
color in the Front Panel Pack.
STEP 1. Remove the two screws that fasten the side
trim to the door frame. See Figure 14.
STEP 2. Slide the trim downward until the upper edge
is free of the console or end cap (about VI”).
STEP 3. Next lift off side trim.
Change Front Panel
CONSOLE-
m
STRIP
STEP 4. Slide the panel(s) (your unit may have one, two
or three panels depending on the model) sideways until
they are clear of the groove in the underside of the con-
sole and the lower trim strip of the door. See Figure 14.
NOTE: There is a corrugated (cardboard) spacer behind
the panel(s) that should be left in place.
Step 5. Select the color you wish to have showing.
CONSOLE L-+
I
GROOVE
l-n
1
LOWER
TRIM
STRIP
Reinstall Panel Pack and Side Trims
STEP 6. Position the panel(s) so that upper edge of
the panel(s) fits into the groove on the underside of the
console, and the lower edge of the panel(s) fit into the
lower door trim. See Figure 15A.
STEP 7. Slide the panel(s) back into place, making sure
the cardboard spacer is in place in the door assembly.
It may be necessary to gently push on the surface of
the panel(s) so they will fit under the edge of the side
trim that is still in place. See Figure 158.
STEP 6. Slide the upper edge of the side trim upward
until it is secure under the lower edge of the console
or end cap. See Figure 1X.
STEP 9. Position the side trim so the two mounting
holes in the side trim align with mounting holes in the
door frame.
STEP 10. Install the two mounting screws in the side
trim.
14
Kommentare zu diesen Handbüchern